Jira - install and configure using Helm
Before installing, review the prerequisites and the general instructions for installation using Helm.
Multi-tenant settings for regions other than the default When you set up Snyk Broker for use in regions other than the default, additional environment variables with specific URLs are required. For the URLs and examples, see Regional hosting and data residency, Broker URLs.
Command to install the Jira integration
To use this chart, you must first add the Snyk Broker Helm Chart by adding the repo:
helm repo add snyk-broker https://snyk.github.io/snyk-broker-helm/
Then, run the following commands to install the Broker and customize the environment variables. For definitions of the environment variables, see Jira - environment variables for Snyk Broker.
Note: for jiraHostname
value do not include https://
You can pass any environment variable of your choice in the Helm command. For details, see Custom additional options for Broker Helm Chart. Follow the instructions for Advanced configuration for Helm Chart installation to make configuration changes as needed.
You can verify that the Broker is running by looking at the settings for your brokered integration in the Snyk Web UI to see a confirmation message that you are connected. You can start importing Projects once you are connected.
Jira PAT authentication for SSO-enabled JIRA
When SSO is enabled, JIRA usually prohibits the use of a username and password and requires the use of a personal access token (PAT).
When SSO is enabled, you must use a specific Jira version that will instead use the authorization header with the bearer token. To use this version, provide the following configuration:
You must use the Helm chart version 2.2.0 or above.
Last updated